The different parameters can be set using a programming menu that can be viewed on the display (2). In order to enter this menu, press and hold the button (3b) for a few seconds and move using the buttons (3a) and (3c) to select the setting to be modified. In this case, press the button (3b) again to make the settings to be modified.

After 10 seconds of inactivity, the coffee machine exits the menu.

By selecting “LANG” the display language can be selected (IT - EN - FR - ES - DE).

Unit of measurement setting “DEGREES”

By selecting the “DEGREES” setting, it is possible to set the unit of measurement “°F ” or “ °C“ used in the parameters.

Function/program to set the coffee brewing temperature. A coffee brewing temperature value from 92°C (min) to 100°C (max) can be selected.

By selecting the “P-COF” setting, the pre- brewing duration can be defined from 0 (no pre-brewing) to 4 (maximum pre-brewing).

The dispensing pre-brewing can be programmed only for manual dispensing, it is not applied to the pre-dosed dispensing.

By selecting the “I-STE” setting, it is possible to set a drier or more humid steam according to the preparation desired. it is possible to select from 1 (drier) to 3 (more humid).

In this mode, it is possible to set a value (5 min -> 10 min -> 30 min -> 60 min) after which the machine goes into stand-by mode.

To exit stand-by mode, it is possible to press one of the buttons (3) and wait for the machine to reach the temperature selected for the coffee before being able to use it.

By selecting “ECO” it is possible to enable (ON) or deactivate (OFF) the release of steam/ hot water.

In this mode, a water hardness value from 1 to 3 can be set.

The machine is factory set to “Hard Water Level - 3”. The machine can be set according to the actual hardness of the water used, thus making the requirement for descaling less frequent.

If you don’t know the water hardness, use the test strip supplied (18) and follow the instructions below:

• Remove the reactive strip supplied (18) from its packaging.

• Fully submerge the strip in a glass of water for about one second.

• Remove the strip from the water and shake it slightly. Read the results after about one minute.

By selecting the “DESCALE” setting, the machine descaling cycle can be started.

Machine settings

Machine settings