 After approx. 10 minutes of no use, the machine goes into Eco mode. Proceed as follows to change this setting:

• Access the programming menu as indicated previously.

• Press the key (11), it will flash 3 times to indicate selection.

• The current setting is shown with the keys switching on, as shown in the following table:

The machine is factory set to “Hard Water Level”. The machine can be set according to the actual hardness of the water used, thus making the requirement for descaling less frequent.

If you don’t know the water hardness, use the test strip supplied (17) and follow the instructions below:

• Remove the reactive strip supplied (17) from its packaging.

• Fully submerge the strip in a glass of water for about one second.

• Remove the strip from the water and shake it slightly. Read the results after about one minute.

• If 5 blue stripes appear on the strip, select “light water” settings.

• If 1 or 2 pink stripes appear on the strip, select the “medium water” setting.

• If 3 or 4 pink stripes appear on the strip, select the “hard water” setting.

• If 5 pink stripes appear on the strip, select the “very hard water” setting. Proceed as follows to change the setting: • Access the programming menu as indicated previously.

• Press the key (12), it will flash 3 times to indicate selection.

• Press the key corresponding to the desired setting to modify the hardness, as indicated in the table.

• The key selected will flash 3 times and a sound will be emitted (if the acoustic signals are active) to indicate the setting has been saved.

 The machine is pre-set to extract coffee at an Optimal temperature, which defines the temperature in the cup. Proceed as follows to change the setting:

• Press the key (13), it will flash 3 times to indicate selection.

• Press the key corresponding to the desired setting to modify the temperature, as indicated in the table.

The machine is set with a Standard pre- brewing mode.

Proceed as follows to change this setting:

• Press the key (14), it will flash 3 times to indicate selection.

• Press the key corresponding to the desired setting to modify the pre-brewing profile, as indicated in the table.

When using pressurised filters (31a-31b), we suggest setting the “Short pre-brewing” profile.

The machine is pre-set with acoustic signals off. They can be turned on by pressing buttons (11) and (13) at the same time for 5 seconds.

To reset the factory settings, press keys (12) and (13) simultaneously for 10 seconds.

Machine settings

Machine settings